Submitted by Sara on 19 August 2007 - 11:39pm
Folder:
Adams, Sara
Difficulty Level:
Simple
Model type:
Basic techniques
This video shows how to perform an open sink and a closed sink.
This video shows how to perform an open sink and a closed sink.
Comments
Submitted by Anonymous (not verified) on 5 December 2010 - 5:03pm Permalink
what is the difference
What is the difference between a sink and inside reverse fold?
Submitted by Sara on 7 December 2010 - 8:17am Permalink
Where should I start?
Well, the paper you fold a sink on is in a totally different shape than when you fold an inside reverse fold. For one, a sink is usually performed on a corner, where both edges that start (or end, if you like) in thar corner are closed, and often at least four layers start in that corner. An inside reverse fold requires one side to be open, so that you can fold the paper inside as required by the step.
Hope this helps a bit, although it by far doesn't tell the whole story,
-- Sara
Submitted by a boss (not verified) on 20 February 2012 - 5:17pm Permalink
i never knew a closed sink...
i never knew there was a closed sink. some of the models i do only use open sink. thank you this video was very help full could u recommend any models i should make? im an intermediate/expert folder....
Add new comment